Adding a unit over Bluetooth from the app

Where: App › Home › "Connect device" (Over Bluetooth, with the unit beside you) or App › My vehicles › "Add over Bluetooth", next to "Add your unit"

With the unit beside you, the Diaglana app connects it to Wi-Fi and adds it to your account without your phone changing network. Every screen has the "?" help.

1. What you need

• An Android 12 or later phone, or an iPhone with iOS 15 or later, with Bluetooth turned on.
• On Android, the "Nearby devices" permission: the app never asks for your location. On iPhone, the Bluetooth permission.
• The setup code on the label and, to add the unit to your account, its activation code.
• On Android 8 to 11 the app asks you to use the unit's Wi-Fi network: hold the button for 6 seconds and follow the guide "Setting up ECO-LITE".

2. Open pairing on the unit

1. Plug in the unit and press its button once, for less than 1 second.
2. The light blinks purple (once per second) for 5 minutes. Each step you complete extends the time, up to 15 minutes at most.

Straight out of the box, or with no saved network, the unit opens Bluetooth pairing by itself when it starts. A short press does not open it if the unit is waiting for you to authorize a remote session or if PassThru is armed or waiting to pair with a PC: in those cases the press is for them.

3. Find the unit

1. Press "Find nearby units".
2. Choose your unit in the list. Its name is DiaglanaOBD- followed by the last 4 digits of the identifier on the label (on ECO-LITE TOOL, ECO-TOOL- followed by those digits). Next to the name you see "Very close" or "A bit far": if it is far, move your phone closer.

4. Confirm it is your unit

1. Type the setup code on the label (12 letters and digits, without 0, O, 1 or I; the same one as for the unit's Wi-Fi network) or press "Scan the label" and point the camera at its "Wi-Fi" QR. If the owner changed the code on the platform, use the new one.
2. The app shows the model, identifier, version and vehicle battery. Check that it is the unit on the label.

Tip: The code never travels over the air: the unit only stores a verifier and the connection is encrypted (AES-256). After 5 wrong codes the unit closes pairing; press its button again to start over.

5. Choose the Wi-Fi

1. Choose your network among the ones the unit sees (with "Good signal" or "Weak signal") or press "Another network (hidden or not listed)" and type its name.
2. Type the password and press "Connect the unit".
3. The unit tests the connection, address, Internet, time and platform. It can take up to a minute.

Only 2.4 GHz networks work. As in setup mode, the unit stores up to 5 networks.

6. Add it to your account and finish

1. While signed in, press "Add to my account". If the unit has its activation code stored (16 letters and digits), it appears already filled in; if not, type the one on the label. You may be asked for two-step verification.
2. Press "Finish". The unit turns Bluetooth off, restarts and connects by itself. The light turns green when it is online.

If you are not signed in, the Wi-Fi is saved anyway and you can add the unit later with its activation code (guide "Adding a unit to your account").

Tip: Bluetooth pairing is new. If something does not work, use the unit's Wi-Fi network: hold the button for 6 seconds.

Open the platform See it in the help centre